Basic Operations 105
When printing is complete, the media will automatically be fed to a position where the
pattern is clearly visible.
10.Measure the distance between the “+” symbols.
Record either the distance between the two center symbols or the average of the
distances between the left, center, and right symbols.
11.Pattern length is displayed in the control panel. Using the d/u buttons, enter the value
recorded in Step 10 and press the Z button.
Secondary Adjustment
12.Perform Steps 1 to 6.
13.Use the d/u buttons to select Secondary and press the Z button twice.
14.The printer will print a test pattern.
When printing is complete, the media will automatically be fed to a position where the
pattern is clearly visible.
Cut the media if necessary. See “Cutting Media” on page 80.
15.Check the pattern and note the pattern number with the lightest colors.
Note:
To rewind the media, press the u button.
To Next Page
Loading...
