Attaching the Paper Basket | 9
2.
Insert the end of one of the shorter square poles into one of the plastic connectors.
3. Slide the pole through the holes in the stabilizers and attach a plastic connector to the other end of the
pole. Then, fasten the plastic connectors in place on each side of the stand.
4. Attach the stack guides to the bottom of the printer. Make sure each guide snaps securely into place.
× 4 (T7270)
× 3 (T5270)
× 2 (T3270)
T-Series_Setup_Guide_S.book Page 9 Tuesday, September 16, 2014 2:53 PM