Loading Roll Paper | 29
8.
Slide the roll paper all the way to the right until it lines up with the adapter guides.
9. Press the button on the control panel. Confirm that Roll Paper is highlighted in the display,
then press the
OK button.
10. Insert the end of the roll paper into the paper slot and pull it through. Make sure the paper is free of
slack and that the end is not folded. If Auto Loading is enabled on the T5270D or T7270D, you hear
a beep. Continue with step 12.
T-Series_Setup_Guide_S.book Page 29 Tuesday, September 16, 2014 2:53 PM
To Next Page
Loading...
Need help?
General