50
Chapter 3 Advanced Usage
Release condition of receive buffer BUSY
• Releases when the remaining receive buffer capacity becomes 256 bytes (initial setting)
• Releases when the remaining receive buffer capacity becomes 138 bytes
Select paper out detector enabled for paper out signal output
• Roll paper out detector (initial settings)
• Disabled
Error signal settings
• Enabled (initial setting)
• Disabled
Pre-feed before next print
• Disabled (initial setting)
• Enabled
Roll paper near-end detection
• Disabled (initial setting)
• Enabled
Network tethering
• Disabled (initial setting)
• Enabled
Paper width
• 80mm (initial setting)
• 58mm
This function is enabled only when Receive buffer capacity is set to 4KB.
• When using this function, the top margin is approximately 10.5 mm.
• This setting becomes invalid if you change the "Amount of top margin by backfeed" setting from
the initial setting (9.5mm (no backfeed)).
The initial setting varies depending on the product specification.
To Next Page
Loading...
