49
Chapter 3 Advanced Usage
*1: Available only with TM Utility for iOS.
Functions
Receive buffer capacity
• 4KB (initial setting)
• 45 bytes
BUSY condition
• Receive buffer full/Offline (initial setting)
• Receive buffer full
Auto line feed
• Normally disabled (initial setting)
• Normally enabled
USB power-saving function
• Disabled
• Enabled (initial setting)
Customized Values
Font B auto replacement
Font C auto replacement
Multi-tone print density
Optional buzzer
Batch rotate print (Upside Down)
Communication condition of USB interface
• For information about how to use the software setting mode, see "Software Setting Mode" on
pa
ge 65.
• All the
settings are available using the ESC/POS commands.
The receive buffer capacity of the USB-A Device Charging connector is 8 K bytes.
In either case above, the printer enters the BUSY state after power is turned on, and when a self-test
is being run.
The USB power-saving function is valid only when the USB interface communication condition is
set to the vendor-defined class and the system configuration is set so that the USB driver can
support the USB power-saving function.
Item\Method
TM Utility for iOS,
for Android
TM-m30II Utility
for Windows
Software
Setting Mode
To Next Page
Loading...
