2-4 Setup Rev. B
Beeper Function
This printer has a “beeper“ function. This function causes beeping in specified situations. The
situations are the following:
❏ The battery remaining is low (Memory switch can enable/disable this function)
❏ The printer can’t find any Access point (wireless LAN). (Memory switch can enable/disable
this function)
❏ Roll paper is out (Memory switch can enable/disable this function)
❏ A error has occurred except “printer temperature error.“ (Memory switch can enable/
disable this function)
❏ Start of status sheet printing
❏ The radio field intensity check is started
❏ The radio field intensity check is processing
Note:
About memory switch, see “Memory Switches” on page 2- 11.
About status sheet, see “Confirming the current LAN setting of the printer” on page 2- 15.
About radio field intensity check processing, see “Radio Field Intensity Check Mode” on page 2- 5.
To Next Page
Loading...
