Epson TM P60 - Printable Area

F-4 Consumable Specifications Rev. B
Note:
The allowable relation between the reflecting rate in the black mark portion (1) and the non black mark
portion (2) must be as shown in the table below:
The reflecting rate means the value which is measured with a Macbeth density meter (PCMII) D filter.
F.1.1 Printable Area
F.1.1.1 Label paper
❏ Printable area for label paper
Example: Liner width: 57.5 mm/Label width: 54 mm
Allowable combination of the reflecting rate [Units: %]
Black mark portion (1) 17 16 15 14 13 or less
Non black mark portion (2) 90 85 80 75 70 or more
57.5 ± 0.5
48.5
1.5
Programmable by
control command
Printable Area
4.75 4.25
1.75±0.75
1.75
±
0.75
54 ± 0.5
17dot 404dot
Printable Area
[Units: mm]
1.5