Epson TM P60 - Switching Issuing Mode; Installing the Roll Paper

2-6 Setup Rev. B
Switching Issuing Mode
The issuing mode can be switched between the label continuous issuing mode and the label
peeler issuing mode by folding the peeler holder under the peeler cover.
Installing the Roll Paper
CAUTION:
Be sure to use roll paper that meets the specifications.
Note:
Do not use paper rolls that have the paper glued to the core.
1. Press the open button to open the roll paper cover and the peeler holder.
2. When using the label continuous issuing mode:
Fold the peeler holder under the peeler cover. This covers the label peeler detector.
When using the label peeler issuing mode:
Peel off the first label, and press the peeler change over lever to lift the peeler holder.