Epson TM P60 - Page 33

Rev. B 2-7 Setup
TM-P60 with Peeler Technical Reference Guide
3. When installing the label paper horizontally:
Set the new roll paper on the inside of the roll paper cover and pull the leading edge of the
roll paper.
When installing the label paper vertically:
Set the new roll paper in the inside of the roll paper cover.
Pull the leading edge of the roll paper.
Align the left edge of the roll paper with the edge of the cover.
Note:
Note the direction the paper comes off the roll.
To use the label in the label peeling issuing mode, peel the first label from the liner, them set the liner to the
peeler roller.
4. Close the roll paper cover.
Note:
When closing the peeler cover, make sure to close it firmly, pressing both ends.