Epson TM P60 - Page 98

A-26 Wireless LAN Setup Detailed Information Rev. B
❏ RTS/CTS Threshold Setting
❏ Roaming Setting
❏ Fragment Threshold Setting
TCP/IP
Click the TCP/IP tab; the dialog below is displayed. Set the TCP/IP.
Item Explanation
Set RTS/CTS
handshake control
Select RTS/CTS handshake control Disable or Enable.
RTS/CTS Threshold [0-
2347]
Set the value, 0-2347.
Item Explanation
Set roaming Select Disable/Enable of the AP Density.
AP Density Select the access point density as Low, Medium, or High.
Item Explanation
Set fragment
threshold
Disable or Enable the Fragment threshold.
Fragment Threshold
[256-2346]
Set the value between 256-2346.