Epson TM-S9000 - Reliability; Roll Paper Unit Reliability; Cut Sheet Unit Reliability

Epson TM-S9000 - 5
Characters per line (depending on paper length)
59 to 126 (Font A)
78 to 169 (Font B)
Character spacing
2 dots/0.01" {0.28 mm} for both fonts
Programmable by command.
Maximum print speed
31.50"/s {800 mm/s}
23.62"/s {600 mm/s}
15.75"/s {400 mm/s}
9.45"/s {240 mm/s}
Print speed depends on image type. You
cannot print at 31.50"/s when printing an
image.
Character specifications
Alphanumeric 95 characters
Extended graphics
128 characters × 11 pages
(including user-defined page)
International 37 characters
Structure Font A: 12 × 24
(including 2-dot horizontal spacing)
Font B: 9 × 17
(including 2-dot horizontal spacing)
Paper feed specifications
Feed method Friction feed
Feed pitch 0.054" {0.1369 mm}
Feed speed 31.50"/s {800 mm/s}
15.75"/s {400 mm/s}
9.45"/s {240 mm/s}
Auto sheet feeder (ASF)/pocket capacities
The auto sheet feeder feeds each document into the
TM-S9000 and the pockets hold the processed output.
ASF capacity ≤ 100 sheets
(paper thickness = ≤ 0.005" {0.13 mm})
Total thickness of all sheets must be ≤ 0.51"
{13 mm}, including uneven sheets (that
were folded and straightened out, etc.).
Insert the sheets along the bottom of the ASF.
One-pocket model
Pocket capacity ≤ 100 sheets
(paper thickness = ≤ 0.005" {0.13 mm})
Total thickness of all sheets must be ≤ 0.51"
{13 mm}, including uneven sheets (that
were folded and straightened out, etc.).
Two-pocket model
Main pocket capacity
≤ 100 sheets
(paper thickness = ≤ 0.005" {0.13 mm})
Total thickness of all sheets must be ≤ 0.51"
{13 mm}, including uneven sheets (that
were folded and straightened out, etc.).
Sub pocket capacity
≤ 50 sheets
(paper thickness = ≤ 0.005" {0.13 mm})
Total thickness of all sheets must be ≤ 0.51"
{13 mm}, including uneven sheets (that
were folded and straightened out, etc.).
Paper must be flat without curls, folds, wrinkles, tears, staples,
or clips. Otherwise, jams may occur.
The ASF uses a translucent photosensor. Do not use paper
with holes at the sensor position. The illustration below shows
where holes are prohibited.
Reliability
Roll paper unit
Print head life: 150 million pulses, 150 km
Mechanism: 20 million lines
Autocutter: 2 million cuts
MTBF: 360,000 hours
MCBF: 96 million lines
Cut sheet unit
Print head life: 6 billion shots/nozzle
ASF: 2 million sheets
MTBF: 180,000 hours
MCBF: 4,940,000 cycles