How to connect an Epson POS printer with Ethernet Interface
http://www.beaglehardware.com/howtoethernet.html[3/4/2011 12:27:20 PM]
6. Click the
download drivers on the printer page
Configuration Utilities to Run on the Computer
Epson Flash Utility
The Epson Flash Utility is normally installed with the Epson printer drives. It is used to upload bitmaps to Epson printers,
but has a simple communication test which will check for basic connectivity between the computer and the printer.
Pressing the "Comm. Test" button on the Setup tab of the utility will give a go/no-go indication of basic connectivity.
Installing the Printer Driver in Windows
Installing the TMNet utility also installs the printer driver in Windows. The printer should be visible in the printers folder of
the Windows Control Panel.
Configuring the Printer in Windows
You need to make a few changes in the printer settings to get it to work with the Ethernet adapter. Specifically you need
to configure the port you are using. Open the printer in the Windows Printer Folder. Select the Ports Tab. Turn off
bidirectional support, if enabled.
You must now add the port as s TCP/IP port. Press "Add Port" and select "Standard TCP/IP Port" , then select "New
To Next Page
Loading...
Need help?
General