8 TM-U295/TM-U295P User’s Manual
English
4. Insert the paper from either the
front or the side, as shown in
illustration
5, until the form
stopper stops it. Use the
markings on the side of the
printer to judge how far to
insert paper.
5. Check the PAPER OUT light.
When you insert the paper correctly, the PAPER OUT light goes out. If
the PAPER OUT light is still on, remove the paper and reinsert it.
Troubleshooting
No lights on the control panel
Check that power supply cables are plugged into the printer correctly, the
power unit, and power outlet.
Make sure power is supplied to the power outlet. If the outlet is controlled by a
switch or timer, use another outlet.
The PAPER OUT light is on, and nothing is printing
Paper is not inserted or is not inserted correctly.
The RELEASE light is flashing, and nothing is printed
Indicates an error. Turn off the printer, be sure no paper is jammed, and turn
it back on. If the
RELEASE light still flashes, contact a qualified service person.
DIP Switch Tables
Serial interface
SW Function ON OFF
1 Data receive error Ignored Prints “?”
2 Receive buffer 35 bytes 512 bytes
3 Handshaking XON/XOFF DTR/DSR
4 Data word length 7 bits 8 bits
5 Parity check Yes No
6 Parity selection Even Odd
7, 8 Transmission speed
(See Serial transmision speed table.)
9 Pin 6 reset Used Not used
10 Pin 25 reset Used Not used
Serial transmission speed
8 7 Transmission speed
ON ON 1200 bps
ON OFF 2400 bps
OFF ON 4800 bps
OFF OFF 9600 bps
Parallel interface
SW Function ON OFF
1 Auto line feed Enabled Disabled
2 Receive buffer 35 bytes 512 bytes
3~9 Undefined — —
10 Internal use Fixed to ON
To Next Page
Loading...
Need help?
General
Weight and Dimensions
