TM-U675/U675P Paper Guide Installation
When you want to use a paper roll that is 76 mm wide, you
need to attach the paper holder and paper roll guide packed
with the printer. Follow the steps below.
Note:
You do not need this with standard 82-83 mm paper rolls.
1. Before attaching the paper guide, change DIP switch 2-4
to ON.
2. Open the paper roll cover and remove the paper roll
take-up device.
3. Insert the paper holder at an angle as shown.
CAUTION:
Be sure that you do not catch the lead wire of the
paper end sensor with the holder when you insert it.
4. Slide the holder in the direction indicated by the arrow
in the illustration above until you feel it click. It should
now be in the position shown in the illustration below.
To Next Page
