Epson TM200 - Page 45

TM200 Service Manual
- 43 -
4. Remove the 2 screws beside the autocutter and the connections from circuit board.
T
o in s t al l, rev e rse t he r e m o v a l p r oced ur e.
CAUTION :
When you installed the autocutter module, you must f o ll ow th e steps below . If y o u do n o t
f o ll ow th em, i t cou l d cause an auto c u tt er o p er at io n f a il u r e .
(1) Secur e th e ri ght sid e scre w.
(2) Secur e th e left sid e scr e w.