TM200 Service Manual
- 51 -
Interface Pi
n Assignments
Pin Pin Name Pin Description and Function
1 P-/STROBE Data Strobe
2 PRINTER_D0 Data Bit 0
3 PRINTER_D1 Data Bit 1
4 PRINTER_D2 Data Bit 2
5 PRINTER_D3 Data Bit 3
6 PRINTER_D4 Data Bit 4
7 PRINTER_D5 Data Bit 5
8 PRINTER_D6 Data Bit 6
9 PRINTER_D7 Data Bit 7
10 P-/ACK Acknowledge receipt of Data
11 P-BUSY Strobe received, Waiting on Acknowledge
12 P-PE Paper Out / Paper Error
13 P-SELECT Daisy-Chain Device Select Signal
14 P-/AF Auto-Feed paper
15 NC
*
16 GND GND
17 GND GND
18 NC
19~30 GND GND
31 P-/INIT Cancel Current Job (May be called /PRIME)
32 P-/ERROR
33 GND
36 P-/SEL IN Select In; Taking low or high sets printer on line or off
line
* NC: Not Connected
To Next Page
Loading...
