Epson WorkForce AL-M200 Series - Page 30

8. If SSID selection screen appears, select the SSID, and then press the button.
9. Enter the PIN code of the printer at the web page of the wireless access point.
10. Wait a few minutes until the printer restarts to establish the wireless network.
11. Print a System Settings page from the operator panel.
For more information, see the User’s Guide.
12. Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.
Note:
When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.
Ad Hoc Setting on the Operator Panel
To configure the wireless settings for an ad-hoc connection where the wireless devices communicate
directly with each other without an access point:
1. On the operator panel, press the
(Menu) button.
2. Select Admin Menu, and then press the
button.
3. Select Network, and then press the
button.
4. Select Wi-Fi Setup, and then press the
button.
5. Select the desired access point, and then press the
button.
If the desired access point does not appear:
a Select Manual Setup, and then press the
button.
b Enter the SSID, and then press the
button.
Use the
or button to enter the desired value, and press the or button to move a
cursor.
c Select Ad-hoc, and then press the
button.
d Select an encryption type, and then press the
button.
AL-M200 Series Wireless Network Setup Guide
Wireless Network Setup Guide 30