❏ IPv6 Address
❏ Enable
Select this when using an IPv6 address.
❏ Disable
Select this when using an IPv4 address.
❏ MS Network Sharing
❏ Enable
Use MS Network service.
❏ Disable
Disables the MS Network service.
❏ File Sharing
Enables or disables the le sharing function.
❏ Link Speed & Duplex
Select an appropriate Ethernet speed and duplex setting. If you select a setting other than Auto, make sure the
setting corresponds to the settings on the hub you are using.
❏ Auto
❏ 10BASE-T Half Duplex
❏ 10BASE-T Full Duplex
❏ 100BASE-TX Half Duplex
❏ 100BASE-TX Full Duplex
Related Information
& “Messages Displayed During Connection Check” on page 220
Checking the Network Connection Status
You can check the network connection status in the following way.
User's Guide
Network Settings
32
To Next Page
Loading...
