Start Here
and not sticking out from the end of the cassette.
4 Slide the edge guides against the paper, but not too
tight. Make sure the paper is under the tabs on the edge
guides.
5 Gently insert the paper cassette.
Note: The paper may slide forward slightly as you insert the
cassette. This is normal.
6 Extend the output tray and raise the stopper as shown.
6
Connect the fax line
To fax, connect the phone cord to a telephone wall jack and
to the LINE port on your product. To connect a telephone or
answering machine, use the EXT. port on your product. See
the Quick Guide for more details.
Note: If you’re connecting to a DSL phone line, you must use a DSL
filter or you won’t be able to fax. Contact your DSL provider for the
necessary filter.
Read these instructions before using your product.
Note for Spanish speakers/Nota para hispanohablantes: Para
obtener instrucciones de configuración en español, consulte la Guía
de instalación en www.epson.com/support/wf3520sp (requiere una
conexión a Internet).
1
Unpack
French control
panel stickers
(included for
Canada only)
Caution: Do not open ink cartridge packages until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all protective materials.
2
Turn on
1 Connect the power cord to the back of the printer and to an
electrical outlet.
Caution: Do not connect to your computer yet.
2 Press the power button.
3
Select settings
1 To select English as your language, press OK. If you want
to change the language, press or to select it, then
press OK.
2 Select your country/region and press OK.
3 Select Summer if Daylight Saving Time is in effect;
otherwise, select Winter. Press OK.
4 Select the date format and press OK.
5 Press the number keys to enter the date and press OK.
6 Select 12h (AM/PM) or 24h and press OK.
7 Press the number keys to enter the time. Then select AM
or PM.
8 Press OK.
Note: You can change the time and date settings using the product’s
control panel. For more information, see the online User’s Guide.
4
Install ink cartridges
1 Lift the scanner unit.
2 Open the cartridge cover.
3 Shake the ink cartridges gently 4 or 5 times, then
unpack them.
4 Remove only the yellow tape from each cartridge.
Caution: Don’t remove any other seals or the cartridges may
leak.
5 Insert the cartridges in the holder for each color. Press
each cartridge down until it clicks.
6 Close the cartridge cover. Press down until it clicks.
Then lower the scanner unit.
7 Ink priming begins. This takes about 6 minutes.
Note: Your printer ships with full cartridges and part of the ink
from the first cartridges is used for priming the printer.
Caution: Don’t turn off the printer while it is priming or you’ll
waste ink.
5
Load paper
For instructions on loading envelopes, photo paper, or legal-
size paper, or using the rear feed slot, see the online User’s
Guide.
1 Pull out the paper cassette.
2 Squeeze and slide out the edge guides.
3 Insert the paper with the glossy or printable side
facedown.
Note: Make sure the paper is loaded against the edge guide
WF-3520
To Next Page
Loading...
