The original was pressed with too much force.
Solutions
If you press with too much force, blurring, smudges, and spots may occur.
Do not press with too much force on the original or the document cover.
& “Placing Originals” on page 35
Straight Lines Appear when Sending Faxes from the ADF
e following causes can be considered.
There is dust or dirt on the ADF or originals.
Solutions
Clean the ADF, and remove any dust or dirt that adheres to the originals.
& “Cleaning the ADF” on page 128
The Image Quality of the Sent Fax is Poor
e following causes can be considered.
The Original Type setting is wrong.
Solutions
Select Fax > Fax Settings > Scan Settings > Original Type, and then change the setting. When the
original you are sending contains text and images, set this to Photo.
The resolution is set to low.
Solutions
If you do not know the performance of the sender’s fax machine, set the following before sending a fax.
❏ Select Fax > Fax Settings and then make the Resolution setting to set the highest quality image.
Solving Problems
>
Printing, Copying, Scanning, and Faxing Quality is Poor
>
The Quality of the Sent Fax is Poor
223
To Next Page
Loading...
