267
7. When the cleaning cycle is finished, you can check to see if the nozzles are clean; click Print Nozzle
Check Pattern and click Print.
8. Check the printed pattern to see if there are gaps in the lines.
Print head is clean
Print head needs cleaning
• If there are no gaps, click Finish.
• If there are gaps or the pattern is faint, click Clean to clean the print head again.
If you don’t see any improvement after cleaning the print head twice, turn the product off and wait at least
6 hours. Then check the print head nozzles and try cleaning the print head again, if necessary. If quality
still does not improve, run a Power Cleaning.
Parent topic: Print Head Cleaning
Related concepts
Print Head Nozzle Check
Power Cleaning
Related tasks
Loading Paper in Cassette 2 (Lower Cassette)
Cleaning the Print Head Using the Product Control Panel
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
