47
Replacing the remote control batteries
1 - Remove the screw using a screwdriver
2 - Push the battery compartment flap to remove it.
3 - Insert 2 AAA (R03) 1,5V batteries in the compartment. Make sure you
observe the right polarity (“+” and “-”).
4 - Place the battery compartment cover.
5 - Tighten the screw
Important!
• Do not let children play with the batteries
• Do not ingest the batteries
• Non-rechargeable batteries should not be recharged;
• The batteries must be inserted with the correct polarity (see diagram);
• An old or leaking battery should be removed from the device and disposed
of safely;
• If the device will not be used for a long time, remove the batteries;
• The battery contacts must not be short-circuited;
• The batteries must be removed from the device before disposal.
TROUBLESHOOTING
Malfunctions are often due to minor causes; consult the table below before contacting the after-sales service. This can save you
time and avoid unnecessary expenses.
Problem Causes, solutions
The device does not work
Check the power supply.
Check the fuse.
The remote control does not work Check the battery
The room is not cooled
Check that the "Cooling" mode is active
Check for good air circulation at the inlet and outlet
Check that the filter is clean and not clogged
Check that the setpoint temperature is lower than the ambient temperature
Check that the doors and windows are properly closed
The device vibrates abnormally Check that it is installed on level and stable ground.
In the event of a persistent problem, contact the after-sales service of your store.
To Next Page
Loading...
