ERA Protect - FACTORY RESET; App-Based Factory Reset; Hardware Factory Reset

Page 13
FACTORY RESET
1.
2.
Select the hamburger menu on your ERA Protect App, select settings
and select the Alarm you would like to factory default under section
‘Alarm settings’.
Once selected, click on the image of your Alarm hub, scroll to the
bottom of the alarm settings and select ‘Delete Hub’.
Once you have confirmed that the Alarm Hub has been deleted from
your account please proceed to the next steps.
3.
4.
Locate the factory reset button hole on the back of the Alarm Hub.
Using the reset pin provided, slot the pin into the reset button hole.
Press and hold the pin on the reset button for 10 seconds until the Hub
LED starts flashing.
Hub LED will flash for approximately 5 – 10 seconds and after that the
Hub has been reset to factory default, please proceed to power cycle
your product.
5.
6.
App:
Alarm:
7.
Your product has now been reset back to factory default. Please proceed to
follow the Alarm hub set up process to install your alarm hub.