Erato GP20+ - Page 4

Instruction manual for installation and operation of automatic pellet burner “ERATO GP20+”
(Version : 02.02.2010 10:36) p. 4/50
5.2.7. Nominal thermal load of the burner...........................................31
5.3. Adjustment of the thermal capacity of the burner...........................32
5.3.1. Decreasing thermal capacity of the burner................................32
5.3.2. Increasing thermal capacity of the burner.................................32
5.4. Stopping the pellet burner..................................................................33
5.5. Turning the burner OFF.....................................................................33
• Emergency burner stop.......................................................................34
5.6. Showing and teaching the end user about the maintenance and
adjustment procedures of the burner ..........................................................35
5.7. Safety and unexpected risks ...............................................................35
5.8. Operation faults and repairing procedures ......................................36
Table 5.3. Automatic pellet burner faults and repair procedures....................42
Table 5.4. Detailed description of control board’s alarm mode indications...43
5.9. Automatic pellet burner “ERATO GP20+” warranty form
completion.......................................................................................................44
5.10. Actions, after the burner is not in exploitation anymore.............44
6. Electrical scheme of automatic pellet burner “ERATO GP20+”..........44
QUALITY CERTIFICATE .............................................................................46
WARRANTY FORM........................................................................................47
WARRANTY CONDITIONS..........................................................................48
WARRANTY SERVICE PROCEDURES LIST...........................................49