Erato GP20+ - Automatic Pellet Burner ERATO GP20+ Warranty Form Completion; Actions, after the Burner Is Not in Exploitation Anymore; Electrical Scheme of Automatic Pellet Burner ERATO GP20; Warranty Form

Instruction manual for installation and operation of automatic pellet burner “ERATO GP20+”
(Version : 02.02.2010 10:36) p. 44/50
5.9. Automatic pellet burner “ERATO GP20+” warranty form
completion.
The applied WARRANTY FORM should be completed, by filling the
required information in the appropriate fields. The assigned field for
signatures and stamp should be completed as well in order to VALIDATE
the WARRANY FORM of the unit.
5.10. Actions, after the burner is not in exploitation anymore.
When the lifetime period of the unit has been completed, then it should be
treated properly in order to preserve environment contamination. The unit
should be dismounted and disassembled by environmentally safe methods. This
requirement is most commonly completed by appropriate components recycling,
considering separate waste disposal and utilization methods.
6. Electrical scheme of automatic pellet burner “ERATO GP20+”
Figure 6.1 shows the principal electrical scheme of automatic pellet burner
“ERATO GP20+”.