10
USE
01
INTENDED USE
This charger is solely for the charging of batteries listed in the TECHNICAL
SPECIFICATION section.
CHARGING YOUR BATTERY PACK (A)
WARNING!
The charger and battery pack are specically designed to
work together so do not attempt to use any other devices. Never insert or
allow metallic objects into your charger or battery pack connections because
an electrical failure and hazard will occur.
1. Slide the battery pack onto the charger.
2. Connect the charger to a suitable power supply.
3. The LED lights on charger show different status as below.
RED LED GREEN LED STATUS REMARK
On
Off HOT/COLD Battery The charger will recover to charge
when the temperature drops to
40°C or raises to 5°C
Flashing
Off Defective
Battery pack or charger is defective
Off
Flashing Charging
Off On fully charged Disconnect charger from power
supply and remove battery pack
from charger
WALL-MOUNT HOLES (B)
The charger has hanging holes for convenient storage. Install screws in the wall 2.25
inches (57.1mm) apart. Use screws sufciently strong to hold the combined weight of the
charger and battery pack .
To Next Page
Loading...
