Erbauer EC18-Li - After Use

11
WARNING! Always charge the battery before storage! Please charge the
battery to reach full or no less than half charge before storage. If the tool
will not be used for long periods of time, charge the battery every
3-6 months.
It is important to disconnect the charger from the power supply after
charging nished.
Cool down battery pack from a just-operated product for approximately
15 minutes before attempting to recharge!
Power / Charging status indicator
The charging status indicator (3) on the charger show the status as described in below
table.
Charging status
indicator (3)
Status Remark
Red light Hot/Cold
battery
The charger will recover to charge when the
temperature back to normal range.
Flashing
red light
Defective Battery pack or charger is defective.
Flashing
green
light
Charging Battery is charging normally.
Green
light
Fully
charged
Disconnect charger from power supply and
remove battery pack from charger.
After use
1. Disconnect charger from power supply and remove battery pack from charger and
let it cool down.
2. Check, clean and store the product as described below.
MNL_Erbauer_GB_12V Charger_EBC12-Li_V8_210422.indd 11 4/22/21 6:22 PM