12
Care & maintenance
WARNING!
Always switch the product off, disconnect the product from the power
supply and let the product cool down before performing inspection,
maintenance and cleaning work!
Only perform care and maintenance work according to these instructions!
All further works must be performed by a qualied specialist!
Clean
1. Clean the product with a dry cloth. Use a brush for areas that are hard to reach.
2. In particular clean the air vents after every use with a cloth and brush.
3. Remove stubborn dust with high pressure air (max. 3 bar).
4. Check for worn or damaged parts. Replace worn parts as necessary or contact an
authorised service centre for repair before using the product again.
NOTE: Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be harmful
to its surfaces.
Maintenance
Before and after each use, check the product and accessories (or attachments) for
wear and damage. If required, exchange them for new ones as described in this
instruction manual. Observe the technical requirements.
01
Power cord
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualied persons in order to avoid a hazard.
MNL_Erbauer_GB_12V Charger_EBC12-Li_V8_210422.indd 12 4/22/21 6:22 PM
To Next Page
Loading...
