Erbauer EC18-Li - Page 29

13
WARNING!
Do not use the product with a defective or a loose power cord!
UK plug (only for UK market)
If you need to replace the tted plug, then follow the instructions below.
IMPORTANT: The wires in the mains lead are coloured in accordance with the following
code:
Blue – Neutral
Brown – Live
As the colours of the wire in the mains lead of this product may not correspond with
the coloured marking identifying the terminals in your plug, proceed as follows. The
wire, which is coloured blue, must be connected to the terminal, which is marked with
N or coloured black. The wire, which is coloured brown, must be connected to the
terminal, which is marked L or coloured red.
5 AMP fuse
approved to
BS 1362
Brown L(Live)
Cable grip
Outer sleeve
rmly clamped
Connect
Blue to
N(Neutral)
WARNING! Never connect live or neutral wires to the earth terminal
of the plug, which is marked with E.
Only t an approved 13 Amp BS 1363 or BS 1363/A plug and the correctly
rated fuse. If in doubt, consult a qualied electrician. If a moulded plug is
tted and has to be removed take great care in disposing of the plug and
severed cable, it must be destroyed to prevent engaging into a socket.
Transportation
1. Disconnect charger from power supply and remove the battery pack.
2. Protect the product from any heavy impact or strong vibrations which may occur
during transportation in vehicles.
3. Secure the product to prevent it from slipping or falling over.
MNL_Erbauer_GB_12V Charger_EBC12-Li_V8_210422.indd 13 4/22/21 6:22 PM