Erbauer EHTP22 - Starting the Engine

25
EHTP22
In more detail . . .
Starting the engine
DANGER! Risk of re!
> Due to any spilled fuel, the equipment can catch re.
> Wipe any spilled fuel up before starting.
> Start the engine a few metres away from the place where you have lled it.
WARNING! Risk of injury!
> Before trying to start the engine, make sure the cutting device does not
touch ground or any objects.
> The cutter blade may start to move during the process of starting. The
starting process is NOT nished yet. ALWAYS squeeze and release the
throttle control lock-out and throttle control to set the engine run at idle
speed! Strictly follow the starting process as instructed!
NOTE: Risk of equipment damage!
Never twist the starter cord around your hand! Only pull on the handle!
Do not suddenly release the recoil starter handle! Allow the rope to return
slowly and in a controlled manner each time it is pulled!
NOTE: If the engine does not start, the engine may be ooded. Flooding is
caused by too much fuel mixture applied at the wrong time and can prevent a
equipment from starting. Follow below procedure:
Remove the spark plug and dry the spark plug. Pull the recoil starter handle
slowly for several times to drain the fuel from the combustion chamber. Wait
until fuel vapours and ret the spark plug. Clean up any spilled fuel and move
the equipment at least 3 metres away before starting the engine to avoid any
accidental re. Wait the engine to cool down then cold start or warm start the
equipment as described.
Operation