ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
a. Do not use saw blades which are damaged or deformed.
Replace table insert when worn.
Use only saw blades recommended by the manufacturer and which
are the exact bore and diameter required for this machine
changing the saw blade beware that the width of the groove cut of the saw blade
shall not less than and thickness of the body of the saw blade shall not be more than
the thickness of the riving blade.
d. Take care that the selection of the saw blade is suitable for the
e. Wear suitable personal protective equipment when necessary, this
Hearing protection to reduce the risk of induced hearing loss.
Respiratory protection to reduce the risk of inhalation of harmful
Wear gloves when handling saw blades and rough material.
shall carried in a holder whenever practicable.
i. Connect circular saws to a dust-collecting device when sawing
The operator shall be informed of the factors that infl uence exposure of dust
e.g. type of material being machined and importance of local extraction (capture or
source) and proper adjustment of hoods/baffi es/chutes.
j. Do not use high speed steel (HS) blad
The push-stick or push block should always be stored with the
a. Use push-sticks or push blocks to feed the workpiece past the saw
b. Use correct adjustment of the riving blade.
c. Use correct adjustment of the upper saw blade guard.
s for which the maximum possibl
less than the maximum spindle speed of the tool and the material to be
f. When transporting the machine use only transportation devices and
do never use guards for handling or transportation.
g. During transportation the upper part of the saw blade should be
covered , for example by the guard.
To Next Page
Loading...
