Erbauer ERB2504SE - Additional Safety Instructions; Key Safety Rules

ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
Before using your table saw, it is critical that you read
and understand these safety rules. Failure to follow these rules could
result in serious injury or damage to the table saw.
1
.
ALWAYS USE SAW BLADE GUARD
for every operation
2.
ALWAYS HOLD WORK FIRMLY
against the mitre gauge or rip fence.
3.
ALWAYS USE
a push stick, especially when ripping narrow stock.
4.
NEVER PERFORM ANY OPERATION FREEHAND
,
which means using only
your hands to support or guide the workpiece. Always use either the fence
or the mitre gauge to position and guide the work.
WARNING: FREEHAND CUTTING IS THE MAJOR CAUSE OF
KICKBACK AND FINGER/HAND AMPUTATIONS.
5.
NEVER STAND
or have any part of your body in line with the path of the saw blade.
Keep your hands out of the saw blade path.
6.
NEVER REACH
behind or over the cutting tool for any reason.
7.
REMOVE
the rip fence when crosscutting.
8.
DO NOT USE
a molding head with this saw.
9.
FEED WORK INTO THE BLADE
against the direction of rotation only.
10.
NEVER
use the rip fence as a cut-off gauge when crosscutting.
11.
NEVER ATTEMPT TO FREE A STALLED SAW BLADE
without fi rst turning the
saw
OFF
. Turn power switch
OFF
immediately to prevent motor damage.
12.
PROVIDE ADEQUATE SUPPORT
to the rear and the sides of the saw table for
long or wide work
pieces.
13.
AVOID AWKWARD OPERATIONS
and hand positions where a sudden slip could
cause your hand to move into the saw blade.
14.
NEVER USE SOLVENTS
to clean plastic parts. Solvents could possibly dissolve
or otherwise damage the material. Only a soft damp cloth should be used to clean plastic
parts.