1 Test programs 9
/ 58
Art. No. 80116-251
08 / 99
Test programs
ICC 50, ICC 80, ICC BIPOLAR
No. Test program function
1 Basic setting of the front panel
2 Calling up the Error list
3 Programming the required activation time limitation
4 Activation of all visual front panel displays
5 Activation of the audible signals
6 Manual closure of the output relays
7 (not assigned)
8 Display of the software version number
9 (not assigned)
10 Measurement of the internal 15 volt supply voltage
11 Automatic verification of the power supply unit for the entire range of 0…90 volts
12 Adjustment of the phase control for the HF generator
13 Calibration of the HF power output
14 Automatic calibration of the NE monitor
15 Verification of the activation signals (accessories) and safety shut off feature
16 Automatic burn-in procedure for two hours
17 Setup of programmable options
18 (not assigned)
19 (not assigned)
20 Selection of content for the CONFIG register of the microcontroller
21 Verification of the modulation timer and the modulation monitor
To Next Page
