Need help?Do you have a question about the Erbe ICC 50 and is the answer not in the manual?
General| Category | Medical Equipment |
|---|---|
| Manufacturer/Brand | Erbe |
| Model | ICC 50 |
| Application | Electrosurgery |
| Frequency | 500 kHz |
| Voltage | 230 V |
| Modes | Cut, Coag |
| Power Supply/Mains Voltage | 100-240 V, 50/60 Hz |
Instructions on how to access and initiate diagnostic test programs.
Procedure for configuring the unit's front panel settings and saving them.
Step-by-step guide for adjusting the HF generator phase control for sinusoidal output.
Process for calibrating the HF power output against a power meter.
Steps for automatically calibrating the Neutral Electrode monitor for proper function.
Guidance on diagnosing and resolving malfunctions using error codes and general troubleshooting tips.
Important notes regarding equipment adjustment, safety, and authorized service personnel.
Procedure for the initial setup and initialization of the unit's microcontroller.
Instructions for setting the phase control of the HF generator using test program 12.
Steps for calibrating the HF power output using test program 13.
Procedure for calibrating the Neutral Electrode monitor using test program 14.
To Next Page
