Ercolina Super Bender 060 User Manual

-1-
060
®
Super Bender
®
Rotary Draw Bender for Pipe, Tube and Prole Bending
Operator’s Manual
WARNING!
BEFORE USE, BE SURE EVERYONE USING THIS MACHINE READS AND
THOROUGHLY UNDERSTANDS ALL SAFETY AND OPERATING INSTRUCTIONS IN THIS MANUAL
Model 060A___________________ Serial # __________________________

Ercolina Super Bender 060 Specifications

General

Brand	Ercolina
Model	Super Bender 060
Category	Power Tool
Language	English

Summary

Limited Warranty

Important Safety Instructions

Special Instructions

Before you Begin

General Identification of Parts

Identifying the main components of the 060® Super Bender® machine.

060® Super Bender® Features

Wiring Instructions and Connections

General Assembly and Setup

Guidance on connecting the foot pedal and changing hex shafts.

Bending Terminology

Definitions of key terms used in the bending process.

Material Selection

Proper tooling selection

Guidelines for selecting appropriate tooling based on material and CLR.

Mounting "roller" counterbending die

Guidance on using roller dies for heavy wall profiles or solids.

Loading workpiece

Steps for correctly positioning and securing the workpiece for bending.

ERCOLINA® ROTARY DRAW TIE BAR ACCESSORY

Special Application Tooling – Part# 030TIEBAR

Bender Programming

Control panel functions

Overview of control panel displays and their functions for operation.

Enter bend angle

Procedure for setting the desired bend angle.

Determining springback setting

Steps to determine and set the springback value for accurate bends.

Entering springback value

How to input the determined springback setting.

Entering slow down setting

Adjusting the slow down setting based on tube diameter for controlled bends.

Adjusting countering bending die support screw

Setting the support screw for optimal bend quality.

Finishing bend

Procedure for completing a bend to the programmed angle.

Editing bend angle and springback values

How to modify programmed bend angles and springback settings.

Initial springback setup

Step-by-step guide for setting up springback for the first time.

Bending Troubleshooting

Routine Maintenance

Troubleshooting

Material Length Required for Rotary Bends in Pipe