16
ENGLISH
TABLE OF CONTENTS
1.0 Introduction page 16
2.0 Technical data page 16
3.0 Transmission system page 17
4.0 Installation and test run page 17
5.0 Operation page 18
6.0 Maintenance page 19
7.0 Electrical device and circuit page 21
8.0 Accessories page 21
1.0 INTRODUCTION
Having bought the Ergofix bench lathe model BV 130 you have become the
owner of a solid and complete machine for family industry, small machinery mills,
maintenance shops, laboratories teaching class show and trial manufacture
workshop etc. This machine is especially suitable for small rod machining. Correct
use and regular maintenance will increase the life of the machine.
In this manual you will find operation and maintenance instructions. Read it
carefully and keep it as a guide to your bench lathe.
The appliance must be used only for the purpose for which it was specifically
designed. All other uses are to be considered incorrect and therefore
unreasonable. The manufacturer cannot be held responsible for any damage
resulting from improper, incorrect or unreasonable use.
This machine is not suitable for external installation.
2.0 TECHNICAL DATA
Centre heigth : 65 mm
Max. distance between centers : 300 mm
Max. rotary dia on lathe bed : 130 mm
Max. rotary dia on tool carries : 62 mm
Cross slide travel : 80 mm
Small slide travel : 55 mm
Main spindle tapered hope : MC 2
Main spindle speed (rpm) : 250, 500, 1000 and 2000
Turning threads metric system : 0,2 - 3 mm (18)
Turning threads Whitworth : 11 - 24 (10)
Longitudinal feed : 0,096 mm 0-16 mm/rpm
Tailstock sleeve travel : 40 mm
Motor : 0,25 kW/230 volt
Accessories : gear changes, claws, chuck and
tool holder wrench
Dimensions (lxbxh) mm : 900 x 380 x 360
Net weight : 62 kg
Gross weight : 75 kg
Order number : 79525
To Next Page
Loading...