ergoline Vertical series - SESSION MANAGEMENT AND SERVICE ACCESS; Stopping Session and Cooling; Accessing the Service Menu; Adjusting Default Tanning Duration

Ergoline Vertical
User manual
Seite 20 von 29
Pressing STOP button the session terminates, and if there’s a cooling time set up the following page
will be shown:
2c C O O L I N
G
S Y S T E M
At the end the program will come back to page 1.
All operations shown before can be executed without any access key.
Service-Mode
Using the access key you can enter inside the service menu: insert the key and press any button, the
following page will be displayed:
3 S E R V I C E M
E N
U
E N
T
Removing the access key, from any page you’ll come back to page 1;
Pressing ENT next page appears:
4 T R E A T D
U
R : 1 0 : 0 0
< > E N
T E S C
Press ESC for going back to page 1
Here it is possible to adjust the default tanning time. (1-30 minutes)
Selecting buttons < or > you can shift to several functions of the menu, and after the last page you’ll
find the first one again:
5 M
I N
U
T E S : 0 0 2 3 1
< > R E S E S C
Press ESC for going back to page 1
Indication of the total unit operating minutes. Keeping pressed RES button for at least 3 seconds
minutes value will be reset to 00000.
6 L A M
P H
O U
R S 0 0 0 0 3
< > R E S E S C
Press ESC for going back to page 1
Indication of the remaining operating hours of the low pressure lamps. Keeping pressed RES button
for at least 3 seconds minutes value will be reset to 00000.
7 U
N I T H
O U
R S 0 0 0 0 3
< > E S C
Press ESC for going back to page 1
Indication of the total unit operating hours. Keeping pressed RES button for at least 3 seconds
minutes value will be reset to 00000.