Trouble Shooting Guide, Advanced
4/00021-3/FEA 209 544/25 C
Ericsson Mobile Communications AB
19(78)
6.3 How to find the fault
The fault can be in either the current measuring or the logical part/the AD-transforming.
Start the board in EFRA with the test program.
Set the battery voltage at 3.7 V
DC
.
Set DCIO at 5.2 V
DC
, and connect the DCIO-voltage to the system connector.
Measure CHSENSE- on R727 (3.7 V
DC
).
Go to Logic \ Current calibration.
Perform the test and measure CHSENSE- on both low and high current,
they should be 3.75 V
DC
and 3.96 V
DC
.
If the voltage is incorrect, the fault depends on R727 or V720.
Also measure R726, it should be 0.0 Ohm.
If the fault still remains it is probably depending on N700.
To Next Page
Loading...
