Ericsson Dialog 3210 - Page 78

Programming and Adjustments
Dialog 3210, 3211 and 321278
Programming of ringing signal tone
character
There are 10 different programmable ringing signal tone characters
on your telephone, each corresponding to a digit between 0 and 9.
Note: If you use melodies to signal incoming calls (3212
telephone only), this will replace the tone character. See
section “Melody ringing” on page 80.
Program on Dialog 3210
H Keep pressed while programming
( 0 — 9 ) Press the corresponding digit
The telephone rings with the chosen character.
H Release
Program on Dialog 3211/3212
Program g Press
The current tone character is displayed (3212 telephone only).
( 0 — 9 ) Press the corresponding digit
The telephone rings with the chosen character.
Program
(g Press to finish programming