15
NORMAL SM+SM P01
DSF SM+SM P02
TITAN SM+SM P03
NORMAL MM+MM P04
ECCENTRIC SM+SM P05
ERBIUM+SM MCVD P06
ERBIUM+SM OVD P07
SM ATTENUATOR P08
SM FIBER LENS P09
SM 80 UM MICRON P10
P11
P12
P13
P14
BB As an optional step, you can then press VIEW to see the
sceen-viewer with a list over all of the the splicing programs
in memory. To scroll through the pages, press VIEW.
To escape from the screen-viewer, press ESC.
View
Screen-viewer for selecting a new program
0-9
0-9
OR
Select new program
C To select a new program, you can either scroll through the
programs using the and buttons, or you can type in
the number of the program you want using the first two
numerical buttons (from the left). Let’s say we wanted to
splice titanium fibers (P03). To do so we would either press
the button twice, or type in “0” with the first numerical
button and “3” with the second.
D You then confirm your selection by pressing ENTER.
E The mode field will then display your new selected pro-
gram (In our example, “TITAN SM + SM”), and in the mes-
sage field the splicer will ask if you want to change the pro-
gram again. If you are satisfied with the splicing program
displayed, press No .
F The splicer will then ask whether you want to edit param-
eters. Splicing program editing is a function taken up in the
section on Advanced Operation (see p. 43), but you should
keep in mind that it is not possible to edit the parameters in
Programs 01-10 (the ones we are using here as examples).
So to end splicing program selection and return to splicing
mode, you should press No again.
The splicer will then update the parameters in memory so
they match those of the splicing program you have chosen,
and return to splicing mode (see definition, following page)To
see a list over the pre-defined programs (Programs 01-10),
you can either look on page 16 of this manual, or follow the
instruction in optional step BB on the next page as to how
you can access the screen-viewer.
Enter
“
“
TITAN SM + SM P03
NEW PROGRAM?
No
“
“
TITAN SM + SM P03
EDIT PARAMETERS?
No
Enter new program
Open screen-viewer
BASIC OPERATION - Splicing mode and program selection
Confirm program choice
Confirm parameters
“
“
UPDATING PARAMETERS...
NORMAL SM + SM P01
EXIT SCREEVIEW, ESC
To Next Page
Loading...