74
Appendix B - Technical data
Appendix B - Technical data
FSU 995 FA Technical data
Fibers Single fiber with a cladding diameter:
30 - 270 mm in Automode (automatic alignment)
30 - 400 mm in Manual mode (manual alignment)
Single fiber with coating diameter up to 2000 mm
Special single fibers including erbium, dispersion shifted and multimode
Splice loss Typical value using identical single mode fibers: 0.02 dB
Fiber clamping On bare fiber with blue V-grooves
On primary coating with black V-grooves
Power supply 90 - 264 V AC, 50 - 60 Hz
13.2 V DC
Battery Splicer only: greater than 100 splices per charge
Splicer and heat oven: greater than 50 splices per charge
Recharging time: 10 hours
Operating environment 0 - 40
o
C, 0 - 95% RH (non-condensing)
Storage environment -40 - 60
o
C, 0 - 95% RH (non-condensing)
Monitor 3” high-resolution LCD monitor
Video output 1 V p-p positive, 75 ohms/CCIR
Size 37 x 22 x 14.5 cm (W x D x H)
(approx. 14.6 x 8.7 x 5.7 in)
Weight 6.45 kg (without power supply)
(approx. 14.2 lbs.)
Transport casing Rugged cabin-sized case with space for all necessary accessories
(54.5 x 42.5 x 25.5 cm (approx. 21.5 x 16.7 x 10 in) W x D x H, upright)
AUX-connector pin description
1 Power ground
2 Not used
3 Not used
4 Not used
5 Not used
6 Disable FSU 995 FA OFF-button (active low)
(To prevent external units from losing power
when using internal power from FSU 995 FA)
7 Optional
8 Not used
9 Power: +12 V DC, Fuse 2A
The AUX-connector is intended for external units
such as a larger monitor.
RS 232 pin description
1 Power ground
2 T x D (Transmit data)
3 R x D (Receive data)
4 RTS (Request to send)
5 To CPU-board (No function)
6 To CPU-board (EXTM-signal)
7 Not used
8 CTS (+12 V, pull-up 1 ko)
9 Power: +12 V DC, Fuse 2A
The RS 232 is intended for serial communication
with a PC or printer.
To Next Page
Loading...