Ericsson FSU 995 F - Set or Change Security

46
0-9 0-9
0-9
ADVANCED OPERATION - Program editing
Set or change security
5
Before you start creating or editing your program it is impor-
tant to stop and determine what type of security you want on
it. If, for example, you just copied the parameters out of one
of the pre-defined programs, the security is classified as
“Open,” meaning that anyone could come along after you
and change the parameters again. If you don’t want this to
happen, you can protect your program by making it either
“Read only” or “Confidential.”
A The first step in changing security is to change the security
code. If you are intending that the program have a security
type other than “Open,” it is necessary to have a code known
only by those who need access to the program’s parameters.
Remember that the security code imported from pre-defined
programs is “00.0,” and is printed in the manual.
To confirm that you want to change the security code, press
Yes .
The message field will then open up for you to enter a new
code by displaying “New code xx.x.” You can then type in
your new code using the number buttons. As always with
security codes, it is best to pick something memorable but
not too obvious.
You enter your new security code by pressing ENTER.
B It is now time to change the security type--to choose
whether the program will be classified as “Open,” “Read
only” or “Confidential.” The splicer will ask in the message
field “Change security type”?, and to do so, press Yes.
If you press No, you go to step 6.
The splicer will then present each possibility one by one. It
will first read “Open?!” in the message field, and if you do not
want the program to be classified as Open you press No. It
will then offer “Read Only?” as an alternative, and after that
“Confidential?” If you press No when it reads “Confidential?”
“Open?!” will come up again.
In short, you scroll through this list with the No button until
the security type you want is shown in the message field, and
then press Yes.
CHANGE SECURITY?
“
“
To change security on
new program
Yes
CHANGE SECURITY CODE
“
“
Confirm wish to change
security code
Yes
NEW CODE xx.x
“
“
Type in new code
Enter
Enter new security code
CHANGE SECURITY TYPE
“
“
To change security type
Yes
OPEN?!
No
READ ONLY?
No
CONFIDENTIAL?
“
“
Choose security type
Yes