Ericsson FSU 995 F - Page 81

79
Appendix C - Service functions flow chart
Service functions
Current test?
N
The current test is
available only if you
are using hot core
alignment process.
Other wise the
question does not
appear.
Clean electrodes?
Y
The current test will
not run until after
you have gone
through the other
service functions.
Y
Electrodes cleaning
program runs
Splicing mode
N
Splicelist handling?
Y
Splice list On
Change splice list on/off?
Y
N
Operator Number 00
Change list codes?
Y
E
List code 1 00
List code 2 00
E
E
N
E
Enter service mode?
N
N
Splicing mode
Fuse
If you chose the current test, you
start it at this point by pressing FUSE.
Current test runs
#
If you have sufficient splice-list
data, you can print.
Print splicelist?
Y
N
Clear splicelist?
Y
N
or
Skip last splice?
Y
N
or