- 17 -
Function C: READ EEPROM
The function "READ EEPROM" is to read full data from a TV set's EEPROM.
First the user must check the TV's EEPROM number for select a) 24C02 or b) 24C04, then the program will ask for
confirmation to read. After that, it will show the values of EEPROM, the user can save it by press «Enter» and enter
the model name.
Computer and Output Test
Test Finished, Now Create Report
Your Computer is :
computer Name : IBM PC/AT
Main Processor : Intel 80486
CPU Speed : 332MHz
Use Enter to Confirm or Esc to Quit
User Parameters Setup
SCL/SDA Pulse Width: 91 (4.7µS = 91)
IIC BUS Write Delay: 51 (1.5µS = 38)
IIC BUS Connected With: LPT1 (Total 1 port)
CA-100 Connected With: COM1 (Total 2 ports)
Serial Port Buad Rate: 9600 (Total 5 kinds)
<Buad Rate = 19200, 9600, 4800, 2400, 1200>
Function D: PC SELF TEST
The user are allowed to run the PC SELF TEST by selecting this option and press <<Enter>>, the computer will show
the system details such as Processor name, CPU Speed of your computer. Further more, the user can adjust the high
level and low level period length of data transfer.
24C02
24C04 (UBM/UBMT)
24C08
Colour TV Channel Parameter Gather
Use Enter to Confirm, Esc to Quit, to Select
---------- NOTE ----------
This part is used to gather parameter of Colour TV channel.
The Colour TV you use must have been adjusted by technician and
passed by EQ. Make sure the EEPROM in your Colour TV is 24C02
(BSAV02 W/O Name) or 24C04 (UBM). Please use - ¯ to select one
and press Enter to Start or press Esc to Quit.
To Next Page
Loading...