# VSH400PLC090909
11. WORK SAFETY AND HYGIENE MANUAL
1. The SH400PLC can be operated by an employee who is of age, who has read the
operation manual and has been trained in safety procedures for the station.
2. Proper positioning of the operating elements should be checked prior to starting
the SH400 PLC machining station.
3. The equipment can be operated only when at full technical performance.
4. Prior to starting up check the following:
• Condition of the electrical system
• oil level in the hydraulic supply
• Condition of mobile elements
• Condition of hydraulic unit
5. Electrical power should be disconnected during daily checks and repairs in order
to prevent accidental machine starting.
6. Personnel should wear adequate protective gear while operating the equipment.
7. The SH400 PLC station should only be used for its intended use.
8. Prevent debris collection around the machining station. In case of high dust
concentration, cover the equipment.
9. Starting the equipment while performing any maintenance (assembly,
disassembly, positioning the machined materials) is forbidden.
10. Switch the generator on only after making sure that the preparation has
been finished and there is no danger of damaging the equipment or
wounding any body parts.
12. SERVICING
ERKO provides full service both during and after the guarantee period.
13. DISPOSAL
After the end of the exploitation period, utilize or recycle the particular elements of this
equipment according to the regulations in force.
To Previous Page
Loading...