24
10. Turn the engine OFF. The key icon on the device should
turn red.
11. Tap the Engine O button.
12. The Ehubo is now testing the external power source to ensure
that the device is receiving the proper voltage from the
diagnostic connector. Tap the OK button to continue.
NOTE: The device might restart if the power supply is not
adequate.
Next, the green check marks on the Installation Complete screen
indicate that the unit has good external power, the wiring checks
are complete, and the system is now ELD ready.
This vehicle is now set up as a pre-2000 vehicle in the Depot
application, which means that you can still activate EROAD logs if
you want to on this truck.
Talk to your Customer Success specialist for more information.
13. Tap the Finished button.
To Next Page
Loading...
