ERT AM3 - Lung Function Measurements; Measurement Preparation

Page 14/40 Version 02.01 • Date 19JAN2017
Prior to starting the measurement, place the ow sensor into the AM3 as shown
below and remove the sealing cap from the ow sensor.
When inserting the ow sensor into the AM3, medical assistants must adhere to the
general hygiene standards valid for hospitals and private practices.
If the ow sensor is inserted into the AM3, the notes on cleaning as described under
the chapter “Cleaning“ must be followed.
4. Lung Function Measurements with the AM3
4.1 Preparing for the Measurement
Sealing cap
Flow sensor
AM3
Flow sensor
The ow sensor can be used multiple times but should only be used by the
same person to prevent contamination.