Need help?Do you have a question about the ESAB Aristo Mig U4000i and is the answer not in the manual?
General| Cooling Type | Forced air |
|---|---|
| Mains Frequency | 50/60 Hz |
| Enclosure Class | IP23 |
| Rated Input Current | 32 A |
| Wire Diameter Range | 0.8 - 1.6 mm |
| Input Voltage | 400 V |
| Duty Cycle | 60% |
Details about the welding power source and its included components.
Guidelines and visual aids for safely lifting the welding equipment.
Instructions on positioning the welding power source to ensure proper airflow.
Checks and requirements for connecting the welding unit to the mains power.
Explanation of the terminating resistor's purpose and placement for CAN bus.
How to connect multiple wire feed units to a single power source.
Identifies and explains the various connectors and controls on the unit.
Step-by-step instructions for powering the welding unit on and off.
Information on how the cooling fans operate during and after welding.
Details on the unit's thermal overload protection system.
Explains the function and connection of the cooling unit for TIG welding.
How to use and connect the remote control unit for adjustments.
Procedure for cleaning the air filter to maintain performance.
Instructions for refilling the coolant in the cooling unit.
To Next Page