ESAB DTB 250 - Page 8

-- 4 0 --
bt10d12e
a-- Option for connecting digital or analogue voltmeter and ammeter.
b-- RP01: Current setting
MMA (A) 20--250
TIG (A) 5--250
c-- RP05: Balance control 40--60%.
d-- Q01: Power switch and lamp, HL1: The lamp light up and the fan starts at
setting ”1”.
e-- HL2: Indicates that thermal cut --out has tripped.
f-- RP03: Choice of slope--down time 0.5--10 sec.
g-- RP04: Choice of slope--up time 0.5--10 sec.
h-- SA3: Switch for selecting 2 or 4 stroke operation.
i-- SA2: Switch for selecting HF on or off.
j-- RP02: Selection of gas post--flow time 0.5--30 sec.
k-- SA4: Switch for selecting welding method and current type.
Following combinations available:
--MMA DC
--MMA AC
-- T I G D C
-- T I G A C
l-- SA1: Switch for selecting remote or local control of welding current.
m-- XS1: Socket for remote control or pulse unit.
n-- XS2: Central connector intended for TIG torch, providing current supply, gas and
switch in single unit.
o-- XS3: Socket for electrode holder.
p-- XS4: Socket for return cable.
bt10d
0
0
2
GB