How to fix an overheated ESAB Water Dispenser torch?
If the ESAB Water Dispenser torch is overheating, first check the coolant flow and make sure that the coolant hose is not folded or damaged. Ensure that you have not exceeded the recommended duty cycle for the weld current. Clean the cooling element using compressed air. Also, check the coolant level.
What to do if ESAB Water Dispenser shows error code "Err 2"?
If error code "Err 2" appears on the power source display of your ESAB Water Dispenser, it indicates that the coolant fluid temperature is too high. Clean the cooling element with compressed air. Wait for the coolant temperature to drop below +55 °C (+131 °F) until the error code disappears. Ensure that you have not exceeded the recommended duty cycle for the weld current.
Why aren't the water pump and cooling fan running on my ESAB EC 1000 Water Dispenser?
If the water pump and cooling fan of your ESAB Water Dispenser are not running, verify that the coolant hoses are properly connected to the quick connectors on the cooling unit. Also, check that the interface cable between the power source and the cooling unit is correctly connected.
General| Brand | ESAB |
|---|---|
| Model | EC 1000 |
| Category | Water Dispenser |
| Language | English |
To Next Page
